How to Apply UVDTF Transfers
UVDTF adds a printed design to a compatible smooth hard blank without weeding or a heat press. The transfer is supplied ready to apply; the blank is separate unless the listing says otherwise.
Ready to apply: no weeding or heat press
These are physical UVDTF transfers, ready to apply without weeding or a heat press. Use on compatible smooth, hard surfaces such as glass, glazed ceramic, acrylic or coated metal. Some smooth plastics also work, but test adhesion first. Avoid fabric, silicone, flexible, textured and non-stick surfaces. Keep designs away from food-contact areas and drinking rims.
How to apply
- Check your design size and position before removing the backing.
- Clean the blank using a method suitable for its material and let it dry completely.
- Rub the transfer firmly onto its clear carrier, then peel the backing away slowly.
- Position carefully: the adhesive grips quickly. Press from the centre outwards and rub every part firmly.
- Peel the clear carrier back slowly. If a detail lifts, lay the film back down and rub again.
Care for your finished make
Allow 24–48 hours before washing. Hand wash gently in warm water; do not soak, scrub the design, put it in a dishwasher or microwave. Surface finish affects adhesion, so test a sample before making a batch. Read the drinkware care guide.
Choose your next project
Shop UVDTF wraps and decals or choose a glass blank. If you are unsure whether a surface works, ask me before ordering.